XGecu T56 – universal LCD smart grid programmer, NAND / EMMC / MCU / ISP TV socket

SKU: SLY-PR011 Category:

Product Description


1.chip support:

  • Based on TL866II Plus, add Nor Flash / NAND Flash / EMMC chip TSOP48 / TSOP56 / BGA48 / BGA63 / BGA64/ BGA100 / BGA153 / BGA162 / BGA169 / BGA221 and other packages support
  • Initial version chip support: 20,900 pieces

2. Hardware parameters of the programmer:

  • PIC32MZ 32-bit MCU 200MHZ + Xilinx SP6 FPGA structure, USB2.0 HS 480MHZ transmission Volume: 12.9cm x 8.5cm x 2.9cm 
  • 56ft full drive I / O design. The maximum operating frequency of all spindles is 50MHZ, which is extremely reliable.
  • Stable and reliable 8P line programming ISP interface, the line length is more than 25CM, can communicate reliably at 25MHZ For 25 / EMMC series online programming, the highest clock frequency can reach 40MHZ-50MHZ 
  • Voltage VCC 1.2-6.5V 64 adjustable levels, VPP voltage 6.5-25V 64 adjustable levels. IO communication signal voltage 1.2V-3.6V continuously adjustable VCC 120MA-320MA continuously adjustable over current protection Protection against overcurrent VPP 120MA.
  • Power consumption: 5V <500MA. Static power consumption: 180mA all the chips do not need an external power supply. It can be connected to an external 5V-5.5V 500MA power supply for YTO 4 multi-machine mass production programming. The external power supply can be powered by cell phone charger or power bank which can be seen anywhere. The programmer has multiple protections for the external power supply: over voltage protection / reverse connection protection / over current protection / under voltage warning.
  • 12MB / s-25MB / s High Speed ​​EMMC Chip Write Speed The read speed of 14MB / s-45MB / s is 2-5 times the speed of similar programmers. (This is very important for large capacity chip, 64GB EMMC chip, If 10MB / s (common programmers cannot reach 10MB / s), it will take 6400 seconds to read, T56 can generally achieve over 20MB / s, as long as about 3000 seconds) Can withstand extremely high speeds, which means the programmer hardware has greater stability when operating at lower speeds
  • Open self-check function, self-check of each channel of VPP / VCC / GND / IO

3.Special introduction to EMMC programming function:

  • EMMC programmer with the most complete functions can perform one-touch mass production operation on EMMC (can also be programmed with more than 4 machines in one belt) Thanks to the project file, all parameters can be loaded at the same time, and programming can be done directly. Read and write speed up to 12MB / s-45MB / s


There are no reviews yet.


Your email address will not be published. Required fields are marked *

Back to top