HX711 module weighing sensor 24 AD module pressure sensor /SCM,DIY preferred for Arduino

This module uses 24 high precision A/D converter chip hx711.

SKU: SLY3610 Categories:

Product Description

DESCRIPTION:

  • This module uses 24 high precision A/D converter chip hx711. It is a specially designed for the high precision electronic scale design, with two analog input channel, the internal integration of 128 times the programmable gain amplifier.
  • The input circuit can be configured to provide a bridge type pressure bridge (such as pressure, weighing sensor mode), is of high precision, low cost is an ideal sampling front-end module.

SPECIFICATION:

  • 1.Two selectable differential input channels
  • 2.On-chip active low noise PGA with selectable gain of 32, 64 and 128
  • 3.On-chip power supply regulator for load-cell and ADC analog power supply
  • 4.On-chip oscillator requiring no external component with optional external crystal
  • 5.On-chip power-on-reset
  • 6.Simple digital control and serial interface: pin-driven controls, no programming needed
  • 7.Selectable 10SPS or 80SPS output data rate
  • 8.Simultaneous 50 and 60Hz supply rejection
  • 9.Current consumption including on-chip analog power supply regulator: normal operation < 1.5mA, power down < 1uA
  • 10.Operation supply voltage range: 2.6 ~ 5.5V
  • 11.Operating Temperature Range:-20 degree ~ +85 degree

Reviews

There are no reviews yet.

Be the first to review “HX711 module weighing sensor 24 AD module pressure sensor /SCM,DIY preferred for Arduino”

Your email address will not be published. Required fields are marked *

Back to top