Finger Measuring Heartbeat Sensor Module for Arduino

This module has 3 pins:

  • S: Analog output signal
  • VCC: Module power supply – 5V
  • GND: Ground
SKU: SLY3434 Category:

Product Description

  • This KY-039 Finger Detection Heartbeat Measuring Sensor Module uses bright infrared (IR) LED and a phototransistor to detect the pulse of the finger, a red LED flashes with each pulse.
  • The LED is the light side of the finger, and the phototransistor on the other side of the finger, phototransistor used to obtain the flux emitted, when the blood pressure pulse by the finger when the resistance of the phototransistor will be slightly changed.
  • We chose a very high resistance resistor R1 because most of the light through the finger is absorbed, it is desirable that the phototransistor is sensitive enough. Resistance can be selected by experiment to get the best results.
  • The most important is to keep the shield stray light into the phototransistor.
  • For home lighting that is particularly important because the lights at home mostly based 50HZ or 60HZ fluctuate, so faint heartbeat will add considerable noise.

Reviews

There are no reviews yet.

Be the first to review “Finger Measuring Heartbeat Sensor Module for Arduino”

Your email address will not be published. Required fields are marked *

Back to top