3 Axis CNC Interface Adapter Breakout Board For Stepper Motor Driver Mach3 TB6560 3.5A with USB Cable

SKU: SLY3976 Category:

Product Description

3 Axis CNC Interface Adapter Breakout Board For Stepper Motor Driver Mach3 TB6560 3.5A+ USB Cable

Features:

* Toshiba TB6560AHQ chip – High power, maximum 3.5A drive current chipset

* 1-1/16 microstep setting – Higher accuracy and smoother operation than standard 1, 1/2 step

* Adjustable drive current settings for each axis – 25%,50%,75%,100% of full current can be set for different stepper motors

* Overload, over-current and over-temperature safety – Full protection for your computer and peripheral equment

* On board current switching – Power output can be set according to specific user requirement

* Full closed-type optical isolation to protect the user’s computer and equipment

* Relay spindle interface – Outputs Max. 36V 7.5A for spindle motors or coolant pump (only one device can be powered by this output!)

* 4 channel inputs interface- Can be used for XYZ limit and emergency stop

* Professional design – Two stage signal processing with super anti-jamming

* Bipolar constant current chopper drive with non-resonant region – Controls motors smoothly through range without creep effect

* Four control inputs (divided into pairs of knives) – Allows setting of limit and emergency stop

* Universal architecture – Supports most parallel software MACH3, KCAM4, EMC2 etc!

 

Important Notes:

Power supply DC 12-36V (not included)

*Voltage Selection:

12-16V DC power supply for Nema 17 stepper motors

16-24V DC power supply for Nema 23 stepper motors

24-36V DC power supply for Nema 34 stepper motors

(High voltage will burn up the chips or stepper motors!!!)

*Ampertage Selection:

Output current of the power supply can be calculated by the following expressions:

Reviews

There are no reviews yet.

Be the first to review “3 Axis CNC Interface Adapter Breakout Board For Stepper Motor Driver Mach3 TB6560 3.5A with USB Cable”

Your email address will not be published. Required fields are marked *

Back to top